WayFinder V7000 Operation Manual page 14

HEADER
INSTALLATION
Windshield Mounting:
1. Install the suction cups into the mounting
bracket by sliding them into their holes
(if not pre-installed).
2. Do not loosen the screw at the pivot point
where the two-piece bracket is assembled
(see illustration next page).
3. Hold the base plate where the suction
cups are attached in one hand and the
compass shaped holder in the other.
4. Pull the sections apart to disengage
teeth and swivel to desired angle while
still maintaining the space between the
bracket teeth. Release once desired angle
is achieved and check that the teeth have
locked securely into place.
5. With the battery and/or 12-volt adapter
installed, slide the unit all the way into the
compass shaped holder until you hear/
feel the "click" when the locking fingers
slip into place and press the suction cup
base firmly against the windshield. If
necessary, apply a thin layer of petroleum
jelly to improve suction cup grip.
6. Insert the small plug end of the 12-volt
adapter into the jack marked "POWER",
12