Kyocera Mita KM-7530 Operation Manual page 247

4 Misfeed in the Duplex Unit 4 4 4 4
If a misfeed occurs in the Duplex Unit, perform the following
procedure to remove the jammed paper.
* When a misfeed has occurred in the Duplex Unit, the following
message will appear after you pull out the Duplex Unit in step 6.
Inch specification
Paper misfeed.
JAM 00
Metric specification
Paper misfeed.
JAM 00
1 Remove the copy eject tray.
If the optional Document Finisher is installed on your copier,
open the front cover to the Document Finisher, pull the
release lever towards you and detach the Document Finisher
from the copier.
3
1
2 Open the left cover to the copier and remove any jammed
paper.
3 If the optional Side Feeder is installed in the copier,
disconnect it from the main body of the copier.
1.Remove paper from duplex unit.
2.Open upper cover and remove paper.
3.Loosen 2-green screws are on rear side of
the duplex unit and open the guide plate.
4.Remove paper.
5.Close cover and reset duplex unit.
1.Remove paper from duplex unit.
2.Open upper cover and remove paper.
3.Remove 2 green screws on rear side of
the duplex unit and open the guide plate.
4.Remove paper.
5.Close cover and reset duplex unit.
2
Section 9 TROUBLESHOOTING
4 Open the upper right cover to the copier and check if there is
any jammed paper. If there is any jammed paper inside that
cover, remove it.
5
Open the front cover to the copier.
6 Pull the Duplex Unit out towards you as far as it will go.
7
Remove any jammed paper.
9-17