Kyocera Mita KM-7530 Operation Manual page 234

Section 9 TROUBLESHOOTING
Message
"Add toner to resume copying."
"Image cycle." ["Now adding toner."]
"Now restoring stored data in HDD."
["Please wait. Now maintaining stored
data."]
"Replace the waste toner box."
"Check the waste punch box."
["Check Punch Hole box."]
"Out of staples. Add staples."
["Stapler empty. Add staples."]
"Time for maintenance."
"Time for replacing Felt Roller."
["Felt cleaning maintenance."]
"Paper misfeed. Remove paper."
"Open drawer xx, check and remove
paper from inside of the machine."
["Open cassette xx, check and remove
paper from inside of machine."]
"Remove paper from inner tray of
Finisher."
"Staple jam. Remove staples."
["Staple jam. Remove staple(s)."]
"Call service."
9-4
There is insufficient toner left in the copier to make copies. Add toner immediately.
Toner is now being added. Please wait until the operation is complete.
The Hard Disk is now being checked. Please wait until the operation is complete.
The waste toner box is full. Replace that box.
The hole punch chad box in the optional Document Finisher is full. Refer to the
Operation Guide for your Document Finisher and dispose of the hole punch chad.
There are no staples left in the optional Document Finisher. Refer to the Operation
Guide for your Document Finisher and load staples.
Periodic maintenance is required to keep your copier in good condition. Contact your
service representative or authorized service center as soon as possible.
It is time to replace certain parts in your copier. Contact your service representative
or authorized service center.
If paper misfeeds, the location of the misfeed will be indicated on the touch panel.
Leave the main switch ON ( | ) and follow the appropriate procedure to remove the
jammed paper.
Check to see if paper has misfed inside one of the drawer[cassette]. if it has, remove
the jammed paper.
There are still copies left in the optional Document Finisher. Remove all of the copies
from the Document Finisher.
Staples have jammed in the optional Document Finisher. Refer to the Operation
Guide for your Document Finisher and remove the jammed staples.
Open and then close the front cover. If this message still remains, make a note of the
number that displayed with the "C", turn the main switch OFF (O), remove the power
plug from the outlet and contact your service representative or authorized service
center.
Procedure Reference
page
3-9
——
——
3-11
——
——
——
——
9-7
9-7
——
——
——