Table of Contents
Advertisement
(3) Loading paper into drawers[cassettes] No.2 and
No.3
Up to 500 sheets of standard copy paper (75 g/m
paper can be loaded into drawers[cassettes] No.2 and No.3.
• Inch specifications
Each drawer[cassette] can hold paper of any size between 11" x 17"
and 5
" x 8
".
1/2
1/2
• Metric specifications
Each drawer[cassette] can hold paper of any size between A3 and
A5R.
IMPORTANT!
• In metric specification copiers, the size of paper loaded in each
drawer[cassette] must be specified under "Paper size
(drawer[cassette] No.2 & No.3)" on page 7-23.
• The type of paper loaded in each drawer[cassette] must be specified
under "Paper type (drawer[cassette] No.1 - No.4)" on page 7-24.
1
Pull the drawer[cassette] that you want to load paper into out
toward you as far as it will go.
* DO NOT pull out more than one drawer[cassette] at a time.
2
Pinch the release levers and move the paper length guide
plate to fit the length of the paper that is to be loaded in that
drawer[cassette]. The paper sizes are marked on the bottom
of the drawer[cassette].
2
– 80 g/m
2
) or color
• Make sure there are no folds, etc., in the paper you load into the
• DO NOT load more paper than is indicated by the sticker located on
• When you are loading paper into the drawer[cassette], make sure
• Be absolutely certain to adjust the paper length and width guides to
• Make sure that the paper is set securely against the paper length
Section 3 PREPARATIONS
3
Pinch the release levers and move the paper width guide
plates to fit the width of the paper that is to be loaded in that
drawer[cassette].
4
Align the paper flush against the right side of the
drawer[cassette], and then set the paper in the
drawer[cassette].
IMPORTANT!
drawer[cassette]. Folds, etc., can cause paper jams.
the inside of the drawer[cassette] (shown as 1 in the illustration).
that the side that was facing upward when you opened the package
is still facing upward.
the appropriate size before setting the paper. Improper setting of
these guides may be the cause of skewed paper feed or paper
jams.
and width guide plates. If there is a gap between the paper and any
guide plate, readjust the guide plates to fit the paper snugly.
1
3-3
Advertisement
Table of Contents
