Removing And Replacing The Optical Drive Filler; Removing And Replacing The Optical Drive - HP Integrity rx2800 i4 User Manual

Removing and replacing the optical drive filler

To remove the component:
CAUTION:
all bays are populated with either a component or a blank.
1. Power off the server
2. Extend or remove the server from the rack.
3. Remove the access panel. See
4. Remove the fans 2 and 3. See
5. Push out the drive filler.
NOTE:
thickness of about 1 mm to push out the drive filler. HP recommends using a ruler or similar
tool.
To replace the component, reverse the removal procedure.

Removing and replacing the optical drive

CAUTION:
all bays are populated with either a component or a blank.
1. Power off the server
2. Extend or remove the server from the rack. See
99).
3. Remove the access panel. See
4. Remove the fans 2 and 3. See
5. Disconnect the drive cable.
HP Confidential
To prevent improper cooling and thermal damage, do not operate the server unless
("Powering off the server" (page
"Removing the access panel" (page
"Removing and replacing a hot-swap fan" (page
You might have to use a nonconductive tool with a length of at least 20 cm and a
To prevent improper cooling and thermal damage, do not operate the server unless
("Powering off the server" (page
"Removing the access panel" (page
"Removing and replacing a hot-swap fan" (page
99)).
42).
99)).
"Removing the server from the rack" (page
42).
Removing and replacing the optical drive filler 107
108).
108).