Table of Contents
Advertisement
Trouble shooting Answer to questions
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
Phenomena
Buzzing upon reservation starts,
Nixie tube indicates "E0"
No or slow drain, nixie tube
indicates "E1" , buzzing.
Running pauses during spin,
nixie tube indicates "E2",
buzzing
Safety switch actuates, not
spin, (after self-correction
twice), nixie tube displays
"E3", buzzing
No or slow water filling (not
reaching the level in 15 min),
nixie tube indicates "E4",
buzzing
Nixie tube indicates "F1"
The machine
does not act
There's abnormal sound
inside the machine
The water faucet leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the "Process selector" button to
select "Spin", but it doesn't work.
There may be some water flowing out of
the drain hose in the first use of the machine.
In the final spinning, it stops and displays
"Rinse", and starts water inlet.
16
The reason
The top lid is not closed
Is the drain hose put down?
Is the drain hose blocked by
foreign material?
The top cover leaves open
Are the laundries put slantingly?
Is the machine slanting?
The water tap is not open
The water inlet valve is blocked
The water pressure is too low
and the current is too small
The water level sensor is
abnormal
Is there power failure?
Is the power plug loose?
Not wash
Does the water level arrive at the
set water level?
Is the power plug loose?
Not spin
Is the top lid closed?
Are the laundries put orderly?
Is the machine slanting?
Are the laundries slanting in
spinning?
Is the jointer screw of the water
inlet hose is loose or twisted
awry?
Close the top lid
Put down the drain hose. Open
and close the top lid once.
Clean the foreign material.
Open and close the top lid once.
Close the top lid
Re-order the laundries. Close
the top lid.Level the machine
in right position.
Open and close the top lid once.
Open the water tap. Push
the "Start/Pause" button.
Clean the water inlet valve.
Push the "Start/Pause" button.
Wait for the normal water
pressure Before use.
Please relate the after-sale
service department.
Use it when the power is on.
Insert the power plug tightly.
Affusion to the set water level.
Insert the power plug tightly.
Close the top lid
Put the laundries orderly.
Level the machine properly.
Re-order the laundries.
Fasten the jointer screw
properly.
Explanation
Balance the laundries to avoid slanting.
The program is setting the drain time. Some
time is needed before it starts spinning.
It is the water remained in the factory
inspection of performance.
It is because that the laundries are slanting
to one side, and the safety switch acts. After
water inlet and stirring, the slanting will be
removed and the spinning will work.
How to settle
Advertisement
Table of Contents
