Table of Contents
Advertisement
Trouble shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes.
Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance
department or after-sale service department of our company. Do not repair it by yourself.
Phenomena
After the reservation is started,
it rings and the digital tube
displays "E0"
The draining does not work,
or the speed of draining is
too slow. The digital tube
displays "E1" and it rings.
It stops running except water
filling and draining. The digital
tube displays "E2" and it rings.
The safety switch acts. The
spinning cannot work (after
twice revising). The digital
tube displays "E3" and it rings.
It does not do water inlet or
the speed is slow (the water
level is not reached after 15
minutes). The digital tube
displays "E4" and it rings.
The machine does not act.
(The indicators are off.)
There's abnormal sound
inside the machine.
The water faucet leaks.
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Pause during washing.
Select spin, but it doesn't work.
There may be some water flowing out of the
drain hose in the first use of the machine.
The Pulsator turns mildly after inlet the water
but always feels immobilly.
Select the heating function
is lighted sometimes twinkles sometimes not.
When the power plug is inserted, the computer board
indicator is switched on, and the machine starts working
16
Reason
The top lid is not closed
Is the drain hose blocked by
foreign material?
Is the drain hose frozen?
After long running of pump in the hot
weather, power will be cut automatically
for safe.
The top lid is not closed
Are the laundries put slantingly?
Is the machine slanting?
Is the water faucet open or is
there water supply failure?
Is the water inlet valve is
blocked
Is there power failure?
Is the power plug loose?
Is the machine slanting?
Is there metal material inside
the washing machine?
Are the laundries slanting in
spinning?
Is the jointer screw of the water
inlet hose is loose or twisted awry?
Balance the laundries to avoid slanting.
supplemental water filled after fabric sensor has checked
fabric (about 48 seconds)
The program is setting the drain time. Some
time is needed before it starts spinning.
It is the water remained in the factory inspection of performance.
If heating function is selected before reaching the selected temperature in order
to let the water heating uniformity the Pulsator turns mildly. After arriving the
selected temperature it can works in gear.
the temperature indicator
When the machine is in heating sate the temperature indicator twinkles.
Select the heating function if not in the sate the lighted does not twinkle.
It is the special power resume function. In the case of power failure
or the power plug is loose during washing the machine can save
the running program
supply is recovered. You do not need to set the program again.
How to settle
Close the top lid
Clean the foreign material. Open
and close the top lid once.
Clean the frozen material.
Some minutes later the machine will
continue to work
Close the top lid
Re-order the laundries. Close the top lid.
Level the machine in right position.
Open and close the top lid once.
Open the water faucet. Open and close
the top lid once.
Clean the water inlet valve. Open and
close the top lid once.
Use it when the power is on.
Insert the power plug tightly.
Level the machine properly.
Fasten the buttons and zipper
Re-order the laundries. Close the
top lid.
Fasten the jointer screw properly.
Explanation
and resume the program after the power
Advertisement
Table of Contents
