Jumpers And Connectors; Setting Jumpers - Advantech UTC-520 User Manual

Intel atom d510 processor-based ubiquitous touch computer with 21.5”led

Hide thumbs Also See for UTC-520:

Table of Contents

4.1 Jumpers and Connectors

You can configure your UTC-520 to match the needs of your application by setting

jumpers. A jumper is the simplest kind of electrical switch. It consists of two metal

pins and a small metal clip (often protected by a plastic cover) that slides over the

pins to connect them. To 'close' a jumper, you connect the pins with the clip. To 'open'

a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1, 2,

and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.

The jumper settings are schematically depicted in this manual as follows:.

A pair of needle-nose pliers may be helpful when working with jumpers. If you have

any doubts about the best hardware configuration for your application, contact your

local distributor or sales representative before you make any changes.

UTC-520 User Manual

open

closed

closed 2-3

Table of Contents

Mmp3-21