Table of Contents
Advertisement
Available languages
Available languages
Specifications (Cont.)
Miscellaneous
• Power Switch
(Red: System standby/Green:System Power boot)
• Thermal warming LED x1; Hard Disk status LED x1
Environment
• Operating Temperature:
-10 ~ 60° C with 0.7m/S air flow: with 1x industrial SSD
0 ~ 40° C with 0.7m/S air flow: with 1x 2.5"HDD or m-SATA
• Storage Temperature: -40 ~ 85° C (-40 ~ 185° F)
• Relative Humidity: 95% @ 40° C (non-condensing)
• Safety test environment: 0~40° C(32~104°F)
Physical Characteristics
• Dimension (W x H x D):
137 x 58 x 118 mm (5.39" x 2.28" x 4.65")
• Weight: 1.1 Kg
Jumpers and Connectors
The board has a number of jumpers that allow you to con-
figure your system to suit your application. The table below
lists the function of each of the jumpers and connectors.
Connectors
Label
Function
VGA1
VGA Connector
DP-HDMI1 DP++ Connector
COM 1
RS-232/422/485
COM 2
RS-232
USB01
USB 3.0
USB23
USB 3.0
DIO1
Digital IO connector
LAN 1
Intel i210IT
Audio
Audio Jack (Line-out, Mic-in)
LED1
Thermal warming LED
LED2
Hard disk status
DC 9-36V
Power connector
1
2
3
AT Mode
PSON1: System AT/ATX Mode Selection
Function
Jumper Setting
1-2
AT Mode
2-3
ATX Mode
2 AIIS-1200 Series Startup Manual
1
2
3
ATX Mode
Software Installation
The drivers for the AIIS-1200 are located on the software
installation CD. Please click through the folder and follow
the on screen instructions to install them.
Caution! The computer is supplied with a battery-pow-
ered realtime clock circuit. There is a danger
of explosion if battery is incorrectly replaced.
Replace only with same or equivalent type
recommended by the manufacturer. Discard
used batteries according to manufacturer's
instructions.
Declaration of Conformity
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditons:
1. This device may not cause harmful interference;
2. This device must accept any interference received,
including interference that may cause undesired
operation.
System I/O Interface
Front View
Thermal
HDD
VGA
LED
LED
PowerButtton
USB3.0Module
PoE1/2LED
PoEModule
Rear View
USB3.0
LAN1
COM1/2
DIO
Advertisement
Table of Contents
