Casablanca Academy Owner's Manual page 11

LIGHT FIXTURE INSTALLATION LIGHT FIXTURE INSTALLATION
ACADEMY GALLERY ONLY - CONTINUED ACADEMY GALLERY ONLY - CONTINUED
Light Kit Installation
Step 10d Remove one of the three light kit screws from
the side of the light kit plate and loosen the other two
as shown in Figure #1.
Step 10e.To attach the light kit, connect the upper plug
connector from the motor to the lower plug connector
in the light kit.
Note: Both plug connectors are polarized
and will only fit together one way. Make sure
the connectors are properly aligned before
connecting them. Incorrect connection could
cause improper operation and damage to the
product.
Step 10f . Align the key hole slots in the switch housing
with the screws installed in step 10d. Raise light kit to
the switch housing and rotate clock wise. Install third
screw into light kit. Then tighten all three screws with
the provided screwdriver.
Note: In compliance with U.S. Federal energy
regulations, this ceiling fan contains a
wattage saver that restricts the light kit
to a maximum of 190 Watts. Exceeding
that limit or the specifications on the
light sockets may result in fire hazard or
improper operation.
20 20 20
Light Kit Screws
Figure #1
Figure #2
Figure #3
A
cAdemy
LIGHT FIXTURE INSTALLATION
ACADEMY GALLERY ONLY - CONTINUED
Glass Installation
Step 10g Remove the three bulbs from their packaging,
and install into the light kit.as shown in Figure #1.
Note: When replaceing bulbs, only replace with
max 40 watt bulbs.
Step 10h.Raise the glass up to the glass adapter on the
bottom of the light kit and route the pull chains through
the center of the bowl.
Step 10i . Route the chains throgh the cover and slide
the cover onto the bottom of the glass.
Step 10j . Screw the finial onto the bottom of the light
kit stem to secure the glass bowl.
Step 10k . Attach the extra pull chains to the light and
fan pull chains using the breakaway connector.
G
ALLery
Figure #1
Glass Adapter
Stem
Cover
Finial
21