Introduction; Before You Start; Safe Use - Casablanca Academy Owner's Manual

PLEASE INSPECT ALL PACKAGING PRIOR TO DISCARDING!
Your Casablanca fan was crafted with pride and care and inspected thoroughly prior to
shipment. Before you begin to assemble and install your Casablanca fan, remove all
parts from the carton and check them against the Parts Guide in this manual.
Make sure all parts are included in the box using the Parts Guide on the following pages.
If there are missing or broken parts:
Call 1-888-227-2178 Monday through Friday, 8 a.m.
to 5 p.m. Central. Your request will be handled
immediately. Replacement parts will be sent to you
via Federal Express.
Proper Parts Handling
Do not remove lightbulbs from their packaging
until you are ready to install them.
Before discarding packaging materials, be certain
that all parts have been removed.
Use a clean, dry paintbrush to remove small
Styrofoam pieces that may remain after unpacking.
Do not brush Styrofoam into wiring cavities.
The blades in each pack are matched for equal
weight to assure smooth fan operation. If more
than one fan is being installed, do not mix blades
from different cartons.
When cleaning, painting, or working near your fan,
be cautious of the fan and blades.
RECORD MODEL AND SERIAL NUMBERS BEFORE INSTALLATION!
Please take a moment to locate the model number and serial number from your fan (see below) and record
this information on the Warranty page inside the front cover of your Owner's Manual if it does not appear
there already. These numbers are found on the motor identification plate affixed to the fan motor in the
location shown below:
Motor Identification Plate
Memphis, TN
DJ06 2237
SERIAL No.:
C38U199K
6 6 6
Always turn power to the ceiling fan OFF before
replacing lightbulbs or working on your fan.
Never insert anything into the path of the fan
blades while the fan is in operation.
Never install a fan over a pool or spa.
Never operate a fan that has been damaged in any
way.
Install the fan according to the instructions in this
manual.
If the fan does not work:
Refer to the Troubleshooting Tips in this Owner's
Manual.
Call Technical Support at 1-888-227-2178.
Contact your local Authorized Service Center.
Our Web site at www.casablancafanco.com
contains additional information on Casablanca
products, troubleshooting, and Authorized Dealer
or Service Centers. Please do not return this
product to the store.
Presidio
TYPE HANGER TYPE
DJ01 1151 MODEL C38U199K
Serial Number
Model Number

INTRODUCTION

BEFORE YOU START

• CAUTION: RISK OF ELECTRICAL SHOCK! Installation is to be in accordance with the National Electrical
Code, ANSI/NFPA 70-1999 and local codes. If you are unfamiliar with the wiring codes, you should use
a qualified electrician.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed
for ceiling fan installations. If it is not, a new box must be installed. Casablanca extension poles are
available for sloped or high ceiling installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit.
The maximum current requirement for the fan with light fixture is 2 amps. The fan uses about 1 amp or
100 watts. Maximum light current is 1amp or 120 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the
canopy, make sure all wires are within the canopy and that no wires are being pinched.
WARNING: Do not bend the blade brackets when installing the brackets, balancing the blades, or
cleaning the fan. Do not insert foreign objects in between the rotating fan blades.
Unpacking
Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check
them against the parts listed in the Parts Guide. Before discarding packaging materials, be certain that all
parts have been removed.
For best performance and for your warranty to be valid, use only genuine Casablanca blades, light
fixtures, and accessories.

SAFE USE

• The blades in each pack are matched for equal
weight to assure smooth fan operation. If more
than one fan is being installed, be careful not to
mix blades from different cartons.
• It is always a good idea to have an assistant to
help with the installation.
• Always turn the power OFF to the ceiling fan
before working on it or replacing lightbulbs.
A A
cAdemy cAdemy
Circuit Breaker
Fuse Box
(Trip breaker for the
(Remove fuse for the
circuit you will be
circuit you will be
working on)
working on)
18"
70"
84"
7 7 7