Casablanca Academy Owner's Manual page 9

LIGHT FIXTURE INSTALLATION (OPTIONAL)
NOTE: If you are installing your fan without a light kit attached as below in Figure #1, continue to Step 9a. If you
have purchased an Academy Gallery Edition, skip this section and go to Step 10 on page 19.
16 16 16
Figure #1
SWITCH HOUSING AND END CAP INSTALLATION
SWITCH HOUSING HARDWARE (not to scale)
Switch Housing
Adapter Plate Cover Plate Cap
Phillips
Switch Housing
Cap Plug Adapter Plate
Screwdriver
Screws (3)
Screws (4)
Switch Housing Installation
Step 9a. Partially install two of the three switch
housing screws onto the switch housing adapter plate
as shown in Figure #1.
Step 9b. Thread the Molex Plug through the hole in
the center of the switch housing and align the two
keyholes with the two screws that were installed on
the switch housing adapter plate. Place the switch
housing over the two screws and rotate it clockwise
so that the two screws are holding the switch housing
as shown in Figures #2 and #3.
Step 9c. Align the screw hole on the switch housing
with the screw hole in the switch housing plate and
insert the third screw as shown in Figure #3. Then
tighten all three screws with the provided screwdriver.
Figure #2
A A
cAdemy cAdemy
Fandangle (2)
Cover Plate
Screw (1)
Figure #1
Figure #3
17 17 17