Generator Shut-Down Procedures - MULTIQUIP WHISPERWATT DCA45SSIU3 Operation And Parts Manual

WARNING
NEVER stop the engine suddenly except in an
emergency.
NORMAL SHUTDOWN PROCEDURE
To shutdown the generator, use the following procedure:
1. Place both the MAIN, GFCI and LOAD circuit breakers
as shown in Figure 49 to the OFF position..
Figure 49. Main, GFCI and Load
Circuit Breakers Off
2. Let the engine cool by running it at low speed for 3-5
minutes with no load applied.
3. Place the ignition switch (Figure 50) in the "
position, remove the key and store in a safe place.
Figure 50. Ignition Switch (Normal)
4. Remove all loads from the generator.
5. Inspect entire generator for any damage or loosening
of components that may have occurred during
operation.
PAGE 36 — DCA45SSIU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #2 (12/19/08)

GENERATOR SHUT-DOWN PROCEDURES

EMERGENCY SHUTDOWN PROCEDURE
1.
2.
STOP"
Place the MAIN, GFCI and LOAD (Figure 51) circuit
breakers to "OFF" position.
Turn the ignition switch key to the "
Figure 51. Ignition Switch (Emergency)
STOP" position.