Table of Contents
Advertisement
norMal shuTDown proCeDure
To shutdown the generator, use the following procedure:
warning
never stop the engine suddenly except in an
emergency.
1. Place the main, g.F.C.i., and aux. circuit breakers
(Figure 37) in the oFF position.
Figure 37. Main, Aux. and GFCI
Circuit Breakers (OFF
2. Let the engine cool by running it at low speed for 3-5
minutes with no load applied.
page 34 — DCa20spxu2 (wiTh MlT20 series) • operaTion anD parTs Manual — rev. #0 (01/18/13)
generatOr shut-dOWn prOcedures
3. Place the MpeC Control switch (Figure 38) to the
4. Verify that all the status LEDs on the MPEC display
5. Remove all loads from the generator.
6. Inspect entire generator for any damage or loosening of
eMergenCY shuTDown proCeDure
1. Place the main, g.F.C.i., and aux. circuit breakers
oFF/reseT position.
AUTO
OFF/RESET
Figure 38. MPEC Control Switch (Off/Reset)
are oFF (not lit).
components that may have occurred during operation.
(Figure 37) in the oFF position.
MANUAL
Advertisement
Table of Contents
