Table of Contents
Advertisement
3.3
Turn the Projector On
1. Ensure that the power cord and signal cable are securely connected. The
Power button on the built in keypad is illuminated.
2. Turn on the lamp by pressing
the built-in keypad. The Status LED is yellow with a long blink.
The startup screen displays in approximately 10 seconds.
3. Turn on the source. Select Input Key on the remote control to select an
input source (VGA, BNC, HDMI, Component, S-Video or Composite
Video).
1
11 12 13 14 15 16 17 18 19 20
4. The projector detects the source you selected and displays the image.
NOTE:
The first time the projector is used, the preferred language may be selected from the main menu after the startup screen is
™
displayed.
3.4
Turn the Projector Off
1. Press
projector. A warning message will appear on the displayed image.
2. Press
the warning message will disappear after 10 seconds.
G Series User Manual
020-000524-02 Rev. 1 (03-2013)
2
3
4
5
6
7
8
9 10
1
11 12 13 14 15 16 17 18 19 20
Power on
1
2
3
4
5
11 12 13 14 15 16 17 18 19 20
on the built-in keypad or on the remote control to turn off the
" "
again to confirm your selection. If you do not press
" "
on the remote control or press
"
"
Status LED
2
3
4
5
6
7
8
9 10
6
7
8
9 10
Section 3: Installation
1
2
3
4
5
6
7
8
11 12 13 14 15 16 17 18 19 20
" "
1
2
3
11 12 13 14 15 16 17 18 19 20
Power on
1
2
3
4
11 12 13 14 15 16 17 18 19 20
Input Key
1
2
3
4
5
6
7
8
9 10
11 12 13 14 15 16 17 18 19 20
again,
" "
9 10
on
4
5
6
7
8
9 10
5
6
7
8
9 10
3-3
Hide quick links:
Advertisement
Table of Contents
