4.
Remove the old lamp: Loosen the three captive screws securing the lamp.
Remove the lamp module slowly and carefully.
5.
Install the new lamp: Replace the lamp with a new one and tighten the three screws. Make
sure the lamp is set properly and secure.
6.
Close the lamp door: Secure the captive screw.
Put the lamp door back.
Reset the lamp hours: Turn the projector ON and use "Reset Lamp Hours" after the lamp
7.
module is replaced.
8.
Once "Reset Lamp Hours" is pressed, a pop up check box will be shown on screen to
ask user to process Auto Brightness Calibration.
It is strongly recommend to do Auto Brightness Calibration after changing lamp to achieve
best accuracy of Constant Intensity control.
G Series User Manual
020-000524-02 Rev. 1 (03-2013)
Section 5: Troubleshooting
4-41