Menvier Security TS2000 User Manual page 48

5.24 Install DC3 (Modem) (Menu 24 continued)
STEP ACTION
19 YES
20
21 (digits)
22 YES
23 YES
24 YES
** = 20 digits
5.25 Reset by Remote (Menu 26)
STEP ACTION
1 -
2 Enter passcode
3 Press up arrow
4 YES
5 YYYY
6 YES
Issue 02 Feb 92
DISPLAY
PLEASE WAIT
MODEM NO
000000000000000000**
MODEM NO
(digits)
SYSTEM NO
0000
MODEM ID CODE
0000000000000000000**
Press <YES> to
INSTALL DC3
DISPLAY
PLEASE CALL ENGINEER
reset required
Press YES to
START SET SEQUENCE
Press YES to
RESET BY REMOTE CODE
SAY XXXX TO ENGINEER
ENTER HIS REPLY >0000
SAY XXXX TO ENGINEER
ENTER HIS REPLY >YYYY
SYSTEM UNSET
(date) (time)
REMARKS
Loading Modem data
Old number displayed. Enter figures of required number. Press NO
to clear all numbers Press YES to accept displayed number
.
Press YES to accept displayed number.
Old number displayed. Enter figures of required number. Press NO
to clear the number. Press to accept number
Old number displayed. Enter figures of required number. Press NO
to clear all numbers Press YES to accept displayed number
.
Press YES to repeat this menu. Press NO to go to Start Set
Sequence. Use arrows to step through menus. Press 0 to quit
REMARKS
Engineer reset required. Call the engineer or select Reset by
Remote menu
Press up arrow to select menu 26 or 0 to quit
Press YES to obtain code number
Inform the engineer (Central Station) of the number shown then
enter the number given in reply (YYYY)
Press YES to accept the reset code
Number accepted and reset effected. If number entered is not
correct return to step 1
Menu only available to User level 2 when Engineer Reset is required
TS2000 (V2+) User Manual
Page 5 - 20