Table of Contents
Advertisement
4.4
Set System and Some or No Wards (without WCU). Circuits may be Omitted
STEP ACTION
1
-
2
Enter passcode
3
YES
4
1 > 8
5
YES
(OR)
6A
YES
6B
-
7
Last exit closed
8
-
* = Sounder on
** = Only Wards with circuits are displayed
Steps 5 to 7 are the Exit Sequence
4.5
Set Wards but not the System. Circuits may be Omitted
STEP ACTION
1
-
2
Enter passcode
3
YES
4
9 & 1 (to) 8
5A
YES
5B
YES
6
0
** = Only Wards with circuits are displayed
If Passcode Standard (W) is used omit steps 3, & 4
Issue 02 Feb 92
DISPLAY
SYSTEM UNSET
(date) (time)
Press YES to
START SET SEQUENCE
SET?:- System (9) &
Ward 1 (to) 8**
SET?:- System (9) &
Ward 1 (to) 8**
Ward set 1 (to) 8**
*YOUR EXIT IS TIMED
xx mins yy secs left
(OR)
*LEAVE VIA EXIT ROUTE
All circuits healthy
*EXIT MODE COMPLETE
Attempting to set
SET SYSTEM . . . . . . . .
(date) (time)
DISPLAY
SYSTEM UNSET
(date) (time)
Press YES to
START SET SEQUENCE
SET?:- System (9) &
Ward 1 to 8**
SET?:- only
Ward 1 (to) 8
Ward set 1 (to) 8
SYSTEM UNSET
(date) (time)
SET
1 (to) 8
(date) (time)
REMARKS
System and all Wards are unset
Press YES to continue. Press 0 to quit. (Press NO to go to other
Menus)
Only Wards with circuits will be displayed. Enter numbers of wards not
to be set - figures will 'toggle'. Press NO to Omit circuits and return -
see Para 5.6. Press 0 to return to step 2. (Press YES to set)
Only Wards remaining and with circuits will be displayed. Press YES to
set these Wards and the system. Press NO to Omit circuits and return -
see Para 5.6. Press 0 to return to step 2
Wards (without WCU) being set, if any, momentarily displayed
Timed exit. Leave via the exit route within the time shown
Leave via the Last Exit and use the Exit Terminator if required
Exit time complete, or Last Exit used, or Last Exit used and Exit
Terminator operated.. Delay for Exit Settling time
System and applicable wards (if any) all set ONLY when the sounder
stops
REMARKS
System and all Wards are unset
Press YES to continue. Press 0 to quit. (Press NO to go to other
Menus)
Only Wards with circuits will be displayed. Enter 9 to delete system and
numbers 1 to 8 of wards not to be set - figures will 'toggle'. Press NO to
Omit circuits & return - see Para 5.6. Press 0 to return to step 2
System deleted. Only Wards not deleted will be displayed. Press YES
to set these Wards and go to step 5A 0r 5B. Press NO to Omit circuits
and return - see Para 5.6. Press 0 to return to step 2
Wards without WCU being set momentarily displayed. Go to step 5B or
6
Wards with WCU being set using Exit procedure. WCU Sounder on.
WCU sounder off. Only the wards indicated are set
TS2000 (V2+) User Manual
Page 4-3
Advertisement
Table of Contents
