Table of Contents
Advertisement
5.7
Chime Facility (Menu 8)
STEP ACTION
1
No*
2
YES
3
YES
4
NO
5
NO
6
YES
7
000
8
YES
9
YES
10A
No
OR
10B
NO
11A
YES
OR
11B
YES
12
YES
13
YES
14
(fig)
15
(YES)
* from last step of previous menu
Issue 02 Feb 92
DISPLAY
Press <YES> to
USE CHIME FACILITY
Press YES to
ALTER CHIME CIRCUITS
CCT >123 Silent
Type or Text
CCT 123 >Silent
Type or Text
CCT 123 >Chimed
Type or Text
CCT >123 Chimed
Type or Text
CCT >000 NOT VALID
YES to continue
Press YES to
USE CHIME FACILITY
Press YES to
ALTER CHIME CIRCUITS
Press <YES> to
ENABLE SYSTEM CHIME
Press YES to
CANCEL SYSTEM CHIME
CHIME ENABLED OK
Press any key
CHIME CLEARED OK
Press any key
Press YES to
ENABLE CHIME WARDS
CHIME ON WARD(S)? :-
* * * * * * * *
CHIME ON :- * * (fig) * *
Press any key
Press YES to
USE CHIME FACILITY
REMARKS
Press YES to use Chime Facility. Press NO to go to use the Printer.
Use arrow keys to step through menus. Press 0 to quit
Press YES to alter circuits that chime. Press NO to go to Enable
System Chime. Press 0 to go to step 1. Use arrow keys to step
through menus
First night circuit which at present is silent. Press YES to go to next
circuit. Press NO to change this circuit. Use arrows to step through
circuits. Enter figures to select circuit
Circuit retained and condition to be changed. Press NO to change
and YES to accept chime or silent
Condition changed. Press YES to accept change . Press NO to
change again then YES to accept.
New condition accepted. Continue steps 3 to 6 for other circuits or
enter 000 to quit
Press YES to return to step 1
Press YES to Use Chime Facility. Press NO to use the Printer. Use
arrow keys to step through menus. Press 0 to quit
Press NO to to go to Enable System Chime.Press YES to alter
circuits that chime. Press 0 to go to step 1. Use arrows to step
through menus.
Press YES to activate System Chime Facility. Press NO to go to
Ward Chime (if applicable) or to step 1 if no wards defined. Use
arrow keys to step through menus. Press 0 to quit
Press YES to disable System Chime Facility. Press NO to go to
Ward Chime (if applicable) or to step 1 if no wards defined. Use
arrow keys to step through menus. Press 0 to quit
System night circuits set to chime will chime if activated. Press any
key to go to step 1 or to step 12
System night circuits set to chime will not chime if activated. Press
any key to go to step 1 or to step 12
Only if Wards are defined. Press YES to enable wards to chime.
Press NO to go to step 1
Night circuits set to chime in wards Wards indicated will chime if
activated. Enter figures to change wards. Enter 0 to clear all wards
Wards indicated will chime. Press any key
Press NO to use the Printer. Press YES to Use Chime Facility.Use
arrow keys to step through menus. Press 0 to quit
TS2000 (V2+) User Manual
Page 5 - 4
Advertisement
Table of Contents
