Table of Contents
Advertisement
5.14
Define Circuits (Menu 15)
STEP ACTION
1
Eng Passcode*
2
YES
3
YES
4
NO
5
YES
6
NO
7**
0
8**
3
9
-
10
000
11
YES
* assumed starting point (may also be from menu 14)
** omit steps 7 and 8 if circuit cannot be allocated to a ward
Issue 02 Feb 92
DISPLAY
Press <YES> to
DEFINE CIRCUITS
001< CIRCUIT TYPE
*
*
*
*
*
002 < CIRCUIT TYPE
*
*
*
*
*
002 > CIRCUIT TYPE
*
*
*
*
*
002
CIRCUIT TYPE
>*
*
*
*
*
002
CIRCUIT TYPE
>Rst *
*
*
*
CCT 002 in Ward(s)
* * * * * * * *
CCT 002 in Ward(s)
* * 3 * * * * *
-
000< NOT VALID
<YES> to continue
Press <YES> to
DEFINE CIRCUITS
REMARKS
Press YES to Define Circuits. Press NO to go to Define Outputs menu.
Use arrow keys to step through menus. Press 0 to quit
Press YES to accept displayed circuit type, attribute and ward. Press
NO to change. Use arrow keys to step through circuits. Enter figures
to select new circuit
Previous display accepted as correct - new circuit displayed. Press
YES to accept displayed circuit type, attribute and ward. Press NO to
change. Use arrow keys or figures for new circuit
Change required.Press YES to accept this Circuit Type. Press NO or
arrow keys to change the circuit type then press YES to accept it
Press NO to change and YES to accept each Attribute. Press 0 to go
to step 7.
Attribute changed. Press Yes to accept then go to next Attribute. Press
0 to continue
when all attributes are correct
Enter ward number to allocate circuit to a ward or to delete the ward if
already allocated. Press YES or 0 to return to step 3 when allocation is
complete
Circuit allocated to Ward 3. Press YES or 0 to return to step 3.
Continue as above until all the fitted circuits have been configured with
type, attribute and ward, if applicable, then at step 3 enter circuit
number 000
Press YES or NO to go to step 1
Press NO to go to Define Outputs menu. Press YES to repeat this
menu. Use arrow keys to step through menus. Press 0 to quit
TS2000 (V2+) User Manual
Page 5 - 11
Advertisement
Table of Contents
