Chapter 5 Other Settings; Set The Grinding Degree - WMF 1000 User Manual

Chapter 5 other settings

5.1 Set the grinding degree

Changing the type of coffee can require resetting the
grinding degree.
Use the included mulititool!
Place the multitool into the grinding degree adjust-

ment on the left side of the coffee machine.
Release coffee dispenser and wait until grinder starts

up
• grinding should be finer: turn clockwise
• grinding should be coarser: turn anticlockwise
• The grinding degree may only be set when the grinder
is running.
• never adjust more than one rotation at a time.
• Do not overwind the stop with force!
The factory setting of the grinding degree is designed for
the qualities of average coffee beans. When adjusting,
there are the following limits:
Grinding degree too fine:
The dispensing stream is interrupted and/or flow fault
-> the ground coffee stops up the brewing filter.
Grinding degree too coarse:
Especially for espresso, the coffee flows too fast, the
crème is too light and has too little body, the aroma is
flat.
Correct setting:
Check your setting by preparing a double shot of
espresso. if the dispensing stream is interrupted here
or if the display indicates a flow fault, set the grinding
degree at least one turn coarser again.
WMF 1000 user manual
other settings
31