Digisol DG-SC4600PI User Manual page 86

When you finish the setting, click 'OK' button to save changes you made, or
click 'Cancel' button to discard all settings you made.
To add or erase blocks:
To add blocks, click + button; to erase blocks, click -
button. Click 'Reset' button to reset motion detection
blocks to default setting. You can also change the color of
block if the color is similar to the IP camera's video and its
difficult for you to identify the blocks by clicking the color
brick between + and - button:
Drag red, green, and blue slide bar to set color, and click
'Set' button to save changes, click 'Default' button to reset
settings, and click 'Cancel' to leave this menu without
saving changes.
You also have to setup sensitivity:
Drag the slide bar to setup sensitivity level from 1 to 10.
Larger number indicates more sensitivity. To apply this
motion detection settings to all IP cameras, click 'Apply to
All Cameras' button.
DG-SC4600I/DG-SC4600PI User Manual
86