Digisol DG-SC4600PI User Manual page 52

Here is the description of every setup item:
Item
Enable RS-485 Check this box to enable RS-485 functionality.
Use Pelco-D
Use Custom
Protocol
When you finish with above settings, click 'Apply' button to save changes.
Select this option and RS-485 interface will output pan-tilt
control signal in Pelco-D format. This format is widely
accepted by most of pan-tilt camera cradles.
You can also input pan-tilt camera cradle's address code in
'Address' field. This code must be identical to pan-tilt
camera cradle's address code.
When the pan-tilt camera cradle does not support Pelco-D
protocol, you can define a protocol's detail by this function.
Please refer to pan-tilt camera cradle's user manual to define
the protocol.
- Baud Rate: Select data baud rate of RS-485 interface
that pan-tilt camera cradle will accept. When the
length of RS-485 connection is very long (longer than
200M), it's not recommended to use high speed
connection (greater than 2400bps).
- Data Bits: Select data bits of RS-485 connection.
- Parity: Select parity bit: odd, even, or space.
- Stop Bit: Select stop bit: 1 or 2.
- Home/Up/Down/Left/Right:
string used to move pan-tilt camera cradle to home or
up/down/left/right position. You can click 'Test'
button to send command string for testing.
- Command 1 ~ 5: You can define extra pan-tilt camera
cradle control strings here by giving it a name
(Command Name) and command string (Hexadecimal
Message). You can also click 'Test' button to send
command string for testing.
DG-SC4600I/DG-SC4600PI User Manual
Description
Input the command
52