Moxa Technologies EtherDevice User Manual page 23

STEP 2: Mounting MOXA EtherDevice Server on the wall
requires 4 screws. Use the server, with wall mount
plates attached, as a guide to mark the correct locations
of the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be less
than 3.5 mm in diameter, as shown in the figure to the
right.
NOTE
Test the screw head and shank size by inserting the
screw into one of the keyhole shaped apertures of
the Wall Mounting Plates, before it is screwed into
the wall.
Do not screw the screws in all the way—leave a space of about
2 mm to allow room for sliding the wall mount panel between the
wall and the screws.
STEP 3: Once the screws are fixed in the wall, insert the four screw heads through the
large parts of the keyhole shaped apertures, and then slide MOXA EtherDevice
Server downwards, as indicated below. Tighten the four screws for added
stability.
Installing MOXA EtherDevice Server
⇒ ⇒ ⇒ ⇒
MOXA EtherDevice Server User's Manual 2-5