Hardware Setup - UNICOM FEP-72104T User Manual

1. Once you confirm the proper software is installed, set the TCP/IP
setting to "Using DHCP Server" or something similar. Proceed to

Hardware Setup.

Hardware Setup
1. Plug the Micro-Router into a standard 110V wall outlet. The Power
LED will turn on. Allow Router 10 seconds to start up.
2. Connect the Router to your primary computer via one of the
router's LAN ports with a Category 5 or higher Ethernet patch cord.
3. Next connect the Router to your Broadband Modem via the router's
WAN port with another Category 5 or higher Ethernet patch cord.
Note: It is important to configure your Micro-Router with the computer
originally attached to your Broadband device. Trying to configure the router
from a different computer on a network is not recommended. If your
Broadband system is new, configure your Broadband device before
configuring your Micro-Router.
8
turn, a device can leave a network smoothly and automatically when it is
no longer in use.
UPnP configuration interface
1. Enable the Universal Plug and Play (UPnP) feature: Activates UPnP.
2. Allow users to make configuration changes through UPnP: Allows
users to configure UPnP-enabled applications.
3. Click button.
Apply
System Maintenance
In Maintenance, there are four functions – Status, DHCP Table, F/W
Upload, and Configuration. Each function is described below.
Status
You can view the Router's current system parameter – System name,
Firmware version, Routing protocol, WAN interface configuration and LAN
interface configuration.
You can also view WAN and LAN interface statistics by clicking the
button. In the Statistic display window, you can set the polling
Show Statistics
interval time. The default value is 5 seconds. To stop polling, click on
button. To start polling, set the Interval Time and click button.
Set Interval
33
Stop