Led Indicators; Desktop Installation; Preparing Your Network - UNICOM FEP-72104T User Manual

Statistic display Window
DHCP Table
This window displays DHCP table information. Click
newest DHCP table information.
F/W Upload
This window allows users to upgrade the router's firmware via an upload.
1. Download the most current firmware upgrade from Unicom's
website. Go to www.unicomlink.com/download.asp.
2. Click button to locate the firmware on the Hard drive and
Browse
then click button to upgrade the Router.
Upload
button to get
Refresh
34

LED Indicators

The LED Indicators give real-time information of systematic operation
status. The following table provides descriptions of LED status and
meaning.
LEDs Status Color
Power On Green
On Green
LK/ACT
LAN
Blinks Green
and
WAN
Off

Desktop Installation

Place the switch on a sufficiently large flat space with a power outlet
nearby. The surface should be clean, smooth, level and sturdy. Make sure
there is enough clearance around the switch, cables, and power cord to
allow adequate air circulation.
Power On
Connect the power cord to the power socket on the rear panel of the
Router. The other side of power cord connects to the power outlet. The
external power supply of the Router works in an AC range of 120VAC and
a frequency of 60Hz.
Check the power indicator on the upper panel to see if power is properly
supplied.

Preparing Your Network

The Micro-Router interfaces with the Internet through TCP/IP, a standard
network protocol. In order to use the router, your computer must have
TCP/IP software. Virtually all computers using a Windows, Macintosh,
Linux, or Unix operating system have the necessary software. Check to
make sure it is installed. Refer to your computer's User's Guide for
information about TCP/IP.
Description
The router is supplied with
suitable power.
The port is connecting with
device.
The port is receiving or
transmitting data.
The port is not linked
successfully with the device.
7