Hardware Description; Front Panel - UNICOM GEP-33224T-1 User Manual

2. Hardware Description

This Section describes the hardware of the DynaGST/2402G Gigabit
Ethernet switch.
The physical dimensions of the DynaGST/2402G Gigabit Ethernet switch is:
440 x 161 x 44 mm (W x D x H)

Front Panel

The Front Panel of the DynaGST/2402G Gigabit Ethernet switch consists of
twenty four (24) auto-negotiation 10/100/1000Mbps Ethernet RJ-45
connectors (with Automatic MDI/MDIX support), two Mini GBIC slots, and
LED indicators (1000, Link/Activity, Full duplex/Collision) for each Gigabit
port and power for the unit.
Figure 2-1. The Front Panel of the DynaGST/2402G Gigabit Ethernet switch
RJ-45 Ports (Auto MDI/MDIX): Twenty-four (24) auto-negotiation
10/100/1000 Mbps Ethernet RJ-45 connectors
Mini GBIC ports: Ports 23 and 24 auto-detect between the Gigabit
copper ports and the Mini GBIC (Gigabit fiber) ports. They support 3.3V
Mini SFP GBIC modules. These modules are optional. There are two
LED indicators for the Mini GBIC ports – LNK and ACT. If a Mini GBIC
module is not installed, ports 23 and 24 operate in Gigabit copper mode
only.
[Note] When the Mini GBIC module is installed, the Mini GBIC (Gigabit
fiber) ports have higher priority than the Gigabit copper ports and supercede
All manuals and user guides at all-guides.com
5