Advertisement
Hardware Description
The Front Panel
The front panel consists of LED Indicators.
Micro-Switch/5
5 Port 10/100Base-TX Switch
Figure 2. Front Panel view of Micro-Switch/5
LEDs
Per Device:
Power
Per Port:
LINK/ACT (Link/Activity)
FDX/COL (Full Duplex/Collision)
The Rear Panel
The rear panel view of the 5-Port Switch ( Auto MDI/MDIX ) consists
of a DC power connector and 5 auto-sensing ports.
1
2
Figure 3. Rear panel view of the Micro-Switch/5
I
RJ-45 Ports ( Auto MDI/MDIX ):
5 ports of 10/100 N-way auto-sensing for 10Base-T or 100Base-TX
connections. [ In general, MDI means connecting to another Hub or
Switch while MDIX means connecting to a workstation or PC. Therefore,
Auto MDI/MDIX means that you can connect to another Switch or
workstation without changing pin-to-pin or crossover cabling. ]
LINK/ACT
Power
FDX/COL
1 2 3 4 5
DC IN
3
4
5
3
I
DC Power Connector
Plug the female connector into the switch and the male connector into
a power outlet. Supports input voltages 9 VDC at 700 mA.
LED-Indicators
Power Indicator
Micro-Switch/5
5 Port 10/100Base-TX Switch
LINK/ACT and FDX/COL Indicators
Figure 4. Front panel view of LED indications
Table lists each the LED and its function.
LED
Status
Color
Power
On
Green
On
Orange
FDX/COL
Blinks
Off
On
Green
LINK/ACT
Blinks
Off
LINK/ACT
Power
FDX/COL
1 2 3 4 5
Description
The switch is supplied with
suitable power.
The port is connecting in
Full Duplex
A packet collision ocurred at
this port. In half-duplex mode,
collisions may occur more
often than in full-duplex mode.
The port is operating in Half
Duplex mode.
The port is connecting at
10Mbps.
The port is receiving or
transmitting data.
The port is not linked
successfully with the device.
4
Advertisement
