Table of Contents
Advertisement
LAN Configuration
Users can configure the DHCP server and the LAN interface in this
section. LAN interface must be configured for network access.
Setup DHCP server
1. DHCP Server: Click the checkbox to enable the DHCP server
feature.
2. IP Pool Starting Address: Assigns the IP pool starting address.
For example: starting from 192.168.1.33, the pool could extend
from 192.168.1.33 to 192.168.1.254.
3. Pool size: The pool size or range depends on where the IP pool
address starts and ends. For example: if the IP goes from
192.168.1.2 to 192.168.1.254, then the pool size is 253 (254 -
1). Remember that the starting number is ALWAYS included in the
pool size total.
4. Primary DNS Server: Fill in the primary DNS server.
5. Secondary DNS Server: Fill in a secondary DNS server as a
backup when the primary DNS server is out of service or offline.
6. Click
button to apply the setting.
Apply
20
LAN Setting
Users must configure the LAN interface for a network connection. The
LAN interface has a default value but can be reconfigured if necessary.
1. IP Address: Assign the LAN interface IP address. The default IP
address is 192.168.1.1.
2. IP Subnet Mask: Assign the LAN IP subnet mask. The default
subnet mask is 255.255.255.0.
3. Multicast: Select the multicast type – IGMP-v1 and IGMP-v2. The
default value is no multicast.
4. RIP Direction: Controls the sending and receiving of RIP packets.
• None: The router will not send any RIP packets and will ignore any
RIP packets received.
• Both: The router will broadcast its routing table periodically and
incorporate the RIP information that it receives.
• InOnly: The router will incorporate the RIP information that it
receives and drop or ignore the rest of RIP packets.
• OutOnly: The router will broadcast its routing table periodically and
drop or ignore the rest of RIP packets.
5. RIP Version: Select the RIP version, RIPv–1, RIP–2B, or RIP–2M.
6. Click
button.
Apply
WAN Configuration
In WAN configuration, users can configure ISP information, the WAN
interface, and the MAC address.
Configure ISP Information
Encapsulation: Select the proper encapsulation type. The three choices
are Ethernet, PPP over Ethernet, and PPTP. Following are the terms
and descriptions.
21
Advertisement
Table of Contents
