Advertisement
4=
Gas orifice spuds are stamped with a number and marked
with 2 color dots. Replace the LP gas orifice spud with the
correct Natural gas orifice spud.
To Convert Oven Broil Burner
Use a 1/2"combination
wrench to loosen the orifice hood away
from the pin (about 2 to 21/2turns). The oven broil burner flame
cannot be properly adjusted if this conversion is not made. See
"Adjust Oven Broil Burner Flame" section.
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Rating
Color
Size
ID
Number
13,500 BTU
Blue/Orange
1.86 mm
N186
9,500 BTU
Blue/Brass
1.51 mm
N151
5,000 BTU
Blue/White
1.12 mm
N112
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the Triple Task Oven Drawer for
proper sizing of spuds for each burner location.
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a 1/2"combination
wrench to loosen the orifice hood
away from the pin (about 2 to 21/2turns). The oven bake
burner flame cannot be properly adjusted if this conversion is
not made. See "Adjust Oven Bake Burner Flame" section.
/
/
A. Orifice hood
:::,:
::1::
Replace access panel (at rear of compartment).
Replace oven
racks in oven cavity. Insert Triple Task Oven Drawer onto slide
rails on sides of drawer opening. Open and close drawer to
ensure it is seated properly on the slides.
1. Refer to the "Make Gas Connection"
section for properly
connecting the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop,
bake and broil burner flame is
very important.
Natural gas flames do not have yellow tips.
3. Refer to "Complete Installation"
in the "Installation
Instructions"
section of this manual to complete this
procedure.
A. Orifice hood
B. Pin
C. Natural gas: increase gas - increase flame size
(preset at factory for Natural gas).
D. LP gas: decrease gas - decrease flame size
15
Advertisement
