Advertisement
3=
Apply masking tape to the end of a %6" nut driver to help hold
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise
and lifting out. Set gas orifice
spud aside.
A
....
_
D
4.
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
Remove the cardboard orifice spud holder located on the
back of the range near the gas inlet. Gas orifice spuds are
stamped with a number, marked with 2 color dots, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct LP gas orifice spud.
A. Groove
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Standard Surface Burners
Burner Rating
Color
Size
ID Number
11,000 BTU
Green/Yellow
0.99 mm
L99
8,000 BTU
Green/Lt. Blue
0.80 mm
L80
5,000 BTU
Green/Brown
0.65 mm
L65
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the Triple Task Oven Drawer for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert
Oven Bake Burner
1. Remove oven racks.
2. Use a 1/2" combination wrench to turn the orifice hood down
snug onto pin (about 2 to 21/2turns).
IMPORTANT:
Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adjust Oven Bake Burner
Flame" section.
_
..... A
C
.........
A. Orifice hood
B. Pin
C. Natural gas: increase gas - increase flame size
(preset at factory for Natural gas)
D. LP gas: decrease gas - decrease flame size
To Convert
Oven Broil Burner
Use a 1/2"combination
wrench to turn the orifice hood down snug
onto the pin (about 2 to 21/2turns).
IMPORTANT:
Do not overtighten.
The oven broil burner flame cannot be properly adjusted if this
conversion is not made. See "Adjust Oven Broil Burner Flame"
section.
A. Orifice hood
:;::,:
::1:::::
Replace access panel (at rear of compartment).
Replace oven
racks in oven cavity. Insert Triple Task Oven Drawer onto slide
rails on sides of drawer opening. Open and close drawer to
ensure it is seated properly on the slides.
13
Advertisement
