Kenmore 66513014K111 Installation Instructions Manual page 9

Helpful Tip: Routing the water line through the left side of
cabinet opening will make water connection easier.
Preferred locations
Drill a 1/2" (1.3 cm) hole in the cabinet side or rear.
Measure overall length of copper tubing or flexible braided
water supply line. Attach to the hot water line using a
connection configuration that is in compliance with local codes
and ordinances. The water line to the dishwasher should have a
manual shutoff valve.
Slowly route water supply line through hole in cabinet. (If you
are using copper tubing, it will bend and kink easily, so be
gentle.) It should be far enough into the cabinet opening to
connect it to the dishwasher inlet on the front left side of the
dishwasher.
Slowly turn water shutoff valve to "ON" position. Flush water
into a shallow pan until clear to get rid of particles that could
clog the inlet valve. Turn shutoff valve to "OFF" position.
S lide nut and ferrule
onto tubing
Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm)
onto copper tubing.