Kenmore 66513014K111 Installation Instructions Manual page 12

Option C_ Waste disposer - with air gap
Drain trap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Connect black end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
4, Attach drain hose to air gap with
large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
If the drain hose was cut, use a 11/2''
to 2" (3.8 to 5 cm) screw-type
clamp (not provided).
5°
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap
to disposer inlet.
Option D_ No waste disposer - with air cjap
£_ J_@ _ _8 ,_ _ _ _ 5 ¸{;_ __8¸¸¸¸ _;_ } ; £: _ 3 _¸¸:¸¸9; __ }_8;;;;;
1. Connect black end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
2° Attach drain hose to air gap with
large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
If the drain hose was cut, use a 11/2 ''
to 2" (3.8 to 5.1 cm) screw-type
clamp (not provided).
3°
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste
tee to air gap.
12