Kenmore 66513014K111 Installation Instructions Manual page 11

Option A_ Waste disposer - no air gap
hose
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
Option B_ No waste disposer - no air cjap
iiiii
1. Connect black end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2.
Attach black end of drain hose to
waste tee with a large silver drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 11/2" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
11