Kenmore 66513014K111 Installation Instructions Manual page 10

NOTE: Toavoid vibration d uring operation, route thewater
supply l inesothatit does nottouch thedishwasher base, frame
or motor.
Connect the3/8" compression fittingtothewater s upply line
priortoinstalling t heunitintothecabinet opening. Attach such
thatthe3/4" connection isfacing upward asshown a bove.
Copper tubing only: P ut t hetubing intothe90° elbow fitting as
farasit willgo(the copper tubing bends a ndkinks e asily). Slide
thenut a ndferrule forward andstart t henut o ntotheelbow
threads.
Flexible b raided connection: Secure nut t oelbow using 5 /8" open
ended wrench o r adjustable wrench.
NOTE: Donotuse Teflon _;t t apewithcompression fittings.
IMPORTANT: Always use a new drain hose. Check local codes
to determine whether an air gap is required.
t®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
If needed, drill a 11/2 '' (3.8 cm) diameter hole in cabinet wall or
side of the opening closest to the sink.
Route drain hose as shown through hole in cabinet to the front
center of opening where drain connection will be made. Tape
drain hose to the floor in area shown. This will prohibit it from
moving when dishwasher is moved into cabinet opening.
Connect drain hose
mect drain } waste tee or
Waste d!sposer- no air gap
OptiOn B; NO waste disposer, no air gap
Option C, waste disposer _ With air gap
tion 3, NO Waste disposer_wkh air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
10