Kenmore 66513014K111 Installation Instructions Manual page 20

Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Co w ect to
Be sure rubber washer is properly seated in fitting. Slide the
3/4" fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
1/4 to 1/2 turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90 ° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
NOTE: Do not use Teflon _t tape with compression fittings.
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of
the drain hose. Push the new drain hose into the black drain
hose connector up to the drain hose stop.
Slide clamp onto
Green clam
Black drain hose
connector --
Stop
Drain hose
hose stop
Using pliers, squeeze open the small green drain hose clamp
and slide onto connector between stops.
After hose is connected, remove towel.
1-®TEFLONis a registered trademark of E.I. Du Pont De Nemours and Company.
20