Volume - Halcro dm10 Owner's Manual

Volume

Front panel
To change the overall volume of the unit, use
the Volume control knob (Fig 1, 9). Turn knob
clockwise to increase
maximum volume is +20 dB) and counter-
clockwise to decrease
minimum volume is -60 dB). To mute the
system, continue to turn the knob counter-
clockwise until the word MUTE appears on the
display, or press the Mute button (Fig 1, 6).
Remote control
To change the overall volume of the unit, use
the Volume buttons on the remote control
(Fig 4, 1). To mute the loudspeakers, press the
Mute button (Fig 4, 2). To un-mute the
loudspeakers press the Mute button again.
Stored volumes
The dm10 memorizes two volume levels.
These setting are for the Headphone output
and the Power Amplifier output.
A volume setting for each programmed input
source is memorized on either power off or on
selection of a different input. On re-selection
of the input, or on power up, the previously
memorized volume is returned.
the volume (the
the volume (the
This accommodates differing source outputs.
For example, a modern CD player may have
an output up to a few volts, whereas an older
type of analog tape recorder may only output
a few hundred millivolts. This feature will return
the volume setting to the previous value.
After power up and switching from Standby to
On the preamplifier will enter the mode it was
last in when the power was turned off.
NOTE: If the mode is such that the
preamplifier output is directed to the power
amplifiers outputs, the power amplifier set of
volumes are used and displayed. By plugging
in the headphones the music will be heard
through both the headphones
amplifier outputs (adjusting the volume on the
preamplifier will not
headphone setting, but it will affect the volume
you hear through the headphones).
Mute
When the Mute button is pressed, the output
to the power amplifier is disabled, the dB
symbol on the display is replaced by a symbol
that looks like a speaker with a line through it
and the headphone volumes are used and
displayed.
If the Mute button is pressed again the
preamplifier output to the power amplifiers is
enabled, the power amplifier volumes are
used, displayed and the dB symbol returns.
22
and the
affect the stored