Dm10 Specifications - Halcro dm10 Owner's Manual

dm10 Specifications

Inputs
• three RCA Unbalanced Voltage Mode
• three XLR Balanced Voltage Mode
• one RCA Current Mode
• any five of the above I/Ps are user
programmable to respond to the device
names; CD, DVD, Tape, Tuner, Aux
• one RCA unbalanced phono
• one XLR balanced phono
• moving coil or moving magnet cartridge
• infinitely variable phono capacitance and
resistance adjustment controls
Outputs
• two pair RCA unbalanced voltage mode,
bridgeable
• two pair XLR balanced voltage mode,
bridgeable
• two pair RCA current mode; 1 pair for un-
bridged connection, the other pair used in
bridged mode
• one pair RCA tape output
• 1/4 inch headphone jack
• six-pin XLR power ON/OFF, both pulsed
and level output control
Power supply
Switch-mode, 110 kHz CW, 4th order mains
filter, 4th order supply rail filter. Fully complies
with EMC and CE standards. Circuit contains
extensive mains transient protection and fault
sensing protection. 85-240 V AC, 50-60 Hz.
Power consumption
100W max via IEC input.
Mains voltage
All voltages from 85 to 240 V AC at 40 to
200 Hz or 120 to 340 V D.C. (Power supply will
operate up to 270 V r.m.s. but IEC sockets
rated up to 240 V by regulatory authorities.)
Controls
On/Standby: Front Panel;
1 x Push Button
Remote Control;
1 x Push Button
Volume: Front Panel;
Optical Rotary
Encoder with Halcro
Flux Detent
Remote Control;
2 x Push Buttons
26