Halcro dm10 Owner's Manual page 24

Volume – balancing function
Front panel
The volume can be evenly distributed though
the speakers or one channel can be louder
than the other. To equalize the outputs of the
speakers to the same volume, depress both
the L and R balance buttons (Fig 1, 4 and 7) on
the front of the unit at the same time.
Using either the Balance Control Right (Fig 1,
7) or the Balance Control Left (Fig 1, 4), you
can change the relative volume for the left and
right channels. Depressing the Right button
will increase the volume on the right hand
channel and decrease the volume on the left.
To change the overall volume of the unit, use
the Volume control knob (Fig 1, 9). Turn knob
clockwise to increase
counter-clockwise to decrease the volume.
To mute the system, when the speakers are
balanced, continue to turn the knob counter-
clockwise until the word MUTE appears on the
display, or press the Mute button (Fig 1, 6).
Remote con rol t
Using the Function key on the remote control
the user can change the relative volume for
the left and right channels.
Depress the function key once (Fig 4, 5). The
display on the preamplifier (Fig 2) will display
BALANCE
, then use the Volume buttons on
the remote control. Depressing the - VOL
button will increase the volume on the left and
decrease the volume on the right. Depressing
the + VOL button will increase the volume on
the right and decrease the volume on the left.
the volume and
Mono/stereo function
Mode can only be selected when the unit is in
the phono mode. To toggle the unit between
Mono and Stereo either press the Mono
button (Fig 1, 11) on the front of the unit or
depress the function key (Fig 4, 5) on the
remote control three times, the display (Fig 2)
will display stereo or mono,
VOL + or VOL – buttons to toggle the unit
between Stereo and Mono.
If mono has been selected while in Phono
mode, Mono mode will be memorized so that
when Phono is next selected, Mono mode will
also be selected.
Phase control
To toggle the unit between in-phase and out-
of-phase mode depress the phase button on
the front panel (Fig 1, 10) or depress the
function key (Fig 4, 5) on the remote control
twice, the display (Fig 2) will display In or Out,
now press either of the volume buttons on the
remote control to toggle the unit between in-
phase and out-of-phase mode.
23
now press either