Halcro dm10 Owner's Manual page 25

Switching between sources
To select a device, press the appropriate
button on the remote control or turn the
selector knob on the front panel until the
device you require appears in the center of
the display. After a few seconds, the center of
the display will revert to displaying the volume
level, though the selected program source will
remain on the lower left hand corner of the
display. Only allocated devices are available.
Note: The Phono Input is always allocated.
If a source is selected (either through the front
panel or remote control) and the correct
source is not selected, ensure that the
program button adjacent
connectors for the selected
illuminated. If it is not, these input connectors
will need to be re-allocated, refer to
setup
, page 20.
24
to the input
source is
Source