Connecting Phono Stage; Connect The Mains Supply Cable; Bridging; Break-In Period - Halcro dm10 Owner's Manual

Connecting phono stage

Connect your turntable to the appropriate
input connectors (Fig 3, 6) located on the left
of the rear panel. The dm10 has the option of
connecting turntables with either balanced or
unbalanced outputs (only
should be connected at any time).
When using unbalanced inputs ensure that
the turntable is grounded
preamplifier's Ground Terminal (Fig 3, 3).
Select either the moving magnet or moving
coil cartridge, (Fig 3, 5) to match your
turntable.
The dm10 has three gain settings for the
phono input: x1, x2 and x4 (Fig 3, 4). This
allows the user to match the preamplifier to
the output of the cartridge. Select appropriate
gain level.
The dm10 can be precisely matched to the
capacitance and resistance of the moving
magnet cartridge by
corresponding knobs at the rear of the unit
(Fig 3, 1 and 2).
The phono button on the remote control is
permanently allocated.
Connect the mains supply
cable
Plug the main power cable into the main
power socket on the rear of the dm10
(Fig 3 13).
one turntable

Bridging

The
through the
amplifiers. A bridging kit can be purchased
through Halcro. For details please E-mail us at:
service@halcro.com

Break-in period

The
completed at the factory. A further break-in
period is not required.
adjusting the
dm10 will control bridged
dm10 electronic break-in
18
power
period is