Installation; Unpacking; Storing Packaging; Positioning - Halcro dm10 Owner's Manual

Installation

Ensure you have read the Important Safety
Information on page 3, before installing your
Halcro preamplifier.
If you require assistance in the unpacking and
installation of your Halcro preamplifier, please
contact your dealer.

Unpacking

o Unscrew the four knurled knobs at the
base of the container and remove the
upper part of the container by lifting
directly upwards, until it clears the top of
the preamplifier.
o Remove the plastic wrapping and foam
pieces, then lift the preamplifier from the
base of the container and remove the
plastic covering from the unit.
Please save all packaging material for later
use.
o Remove the center piece of foam in the
base of the transit case, to locate the
remote control and power cable.
o Wearing the white cotton gloves provided
(to prevent marking the amplifier while
moving it in to position), move the unit to
its final location (see Positioning).
Do not connect to mains power
until all the connections are
made and checked.

Storing packaging

The packaging is custom-designed to prevent
damage from occurring during transport.
Store the packaging in a dry location.

Positioning

The Halcro dm10 preamplifier can be placed
anywhere indoors. There is no need to leave
room around the unit to allow for ventilation as
the dm10 does not generate significant
amounts of heat.
To ensure ultimate performance and to avoid
potential safety hazards, place the unit on a
firm and level surface. When placing the unit
on a shelf, be certain that the shelf and
mounting hardware can support the weight of
the product.
9