Operation; Start Up; Source Setup; De-Allocating Program Buttons - Halcro dm10 Owner's Manual

Operation

Start up

Press the main power switch to On.
When the unit is switched on at the main
power switch (Fig 3, 13) the preamplifier will go
into Standby mode.
Switch the unit on by pressing the Standby/On
button on the unit or the remote control. To
return the unit to Standby mode, press the
Standby/On button again.
NOTE: To continue the setup
process, the unit must be On,
not in Standby.

Source setup

All inputs must be allocated using the remote
Note
control (Fig 4). : The Phono selection is
permanently allocated to the Phono inputs.
Once the signal source units (such as a CD
player) have been connected to the input
connector terminals (Fig 3, 7), ensure the
preamplifier is On, not in Standby mode.
Depress the applicable program button (Fig 3,
8) then simultaneously point the remote
control to a remote sensor window (Fig 1, 2
OR Fig 3, 12) and press the button on the
remote control which corresponds to the
signal source unit you have connected.
The program button will flash twice and will
remain illuminated, indicating the pair of input
connectors are now allocated to the selected
signal source unit. Repeat this process for all
signal source units (maximum
Phono).
De-allocating program
buttons
To de-allocate program buttons, press and
hold the applicable program button and
simultaneously point the remote control to a
remote sensor window and press the Mute
button. The Program button will flash twice
and then remain off. This input has now been
de-allocated and can be used for another
signal source unit.
NOTE: Ensure the location being de-allocated
is not the currently selected input, the
currently selected input
allocated.
20
five plus
cannot be de-