Halcro dm10 Owner's Manual page 30

Phono equalization
Conforms within +/-0.5 dB
standard.
PCB
Four-layer PCBs for ultra high accuracy
reference potentials.
Components
Vishay 0.5% resistors and FKP1 1250V or
MKP10 in critical audio signal paths.
Input programming
Each input may be assigned to a source. The
assigned source is defined on the display and
on the remote control. This is memorized and
may be either reprogrammed or un-assigned.
The programming is performed using the
remote and a remote input receiver resides
both on the front and rear panel for flexibility of
implementation. The program status of each
input is displayed on a LED associated with
each input.
Memory
of the RIAA All volume gain settings for each programmed
input (source) are remembered upon either
power off or upon selection to a different
input. Upon re-selection to each input, or
upon power up, the previously remembered
volume for each input is reinstated.
This accommodates differing source outputs.
For example, a modern CD player may have
an output up to a few volts, whereas an older
type of analog tape recorder may only attain a
few hundred millivolts. This memory feature
thus will return the volume setting at the
appropriate previously set value.
29