Protecting Your Disks - US Robotics USR8700 User Manual

11. On the confirmation message, click OK.
The license is now activated and you can continue to backup up and recover your data.
12. To close the dialog box, click Exit.
Replacing Your Existing License
To replace your existing license:
1. From the Action menu, click License > Add License.
The Add License dialog box displays your current license key code.
2. In License key code, enter the new key code.
3. Click OK.
4. When the confirmation message appears, click OK.
If your computer has an Internet connection, the license is activated automatically. If your Internet con-
nection is temporarily down, your license will be activated automatically the next time you run DiskSafe
Express with a restored Internet connection. If this computer does not have an Internet connection,
you must perform offline activation (as described in the previous section.)

Protecting Your Disks

After you install DiskSafe Express and restart your computer, the Protect a Disk wizard runs automatically.
Using this wizard, you can specify which disk or partition you need to back up, where the backups should
be stored, when automatic backups (if any) should occur, and what password you need to use for the
recovery CD. If you cancel this wizard, you can start it again at any time using the following procedure.
To protect a disk:
1. Click Protect a Disk.
The Protect a Disk wizard runs.
Serial ATA 4-Drive NAS
User Guide
Protecting Local Disks - 98