Wan Port Configuration - E-Lins H980 Series User Manual

H980 Series 3G Router User Manual
【LCP Echo Interval】: Set LCP's maximum interval time, in second.
【LCP Echo Failure】: Set LCP's maximum request times.
【MTU】: Set the number of bytes of the maximum transfer unit.
【MRU】: Set the number of bytes of the maximum receive unit.
【local IP】: Set the local IP address.
【Remote IP】: Set the remote terminal's IP address.
【Other Options】: Users can define their own options here.
3.3.2.2

WAN port configuration

In the "Interface" main tab, click "WAN" sub-tab and enter WAN port setting, and select
internet connection method from "Mode Type" pull-down menu. The WAN port
connection method is "Disable "Static IP", "Automatic Configuration—DHCP" and
"PPPoE". Default is "Disable" that means the WAN port route function is not started.
The different modes of WAN port configuration are described as shown below:
1. Static IP configuration
When the H980 and external network are connected by fixed line, select "Static IP"
option, and enter the following configuration interface:
WAN port support three static IP addresses setting:
【WAN IP Address】: set the primary IP address, generally depending on ISP or
the interface of the directly linked equipment.
【Subnet Mask】: set the subnet mask of the primary IP address.
【Gateway】: set the gateway. it is in the same network segment as IP address,
generally provided by ISP or the interface IP address of the directly linked
equipment.
【Primary DNS】: set the main DNS server's address, which can be empty.
Fig. 3.3-4: static IP configuration interface
28