Chapter 1 1 Preparation job before configuration 1.1 Learn your router version and feature 1) H700 series contains different version and option feature. Please learn it before using it. H700 series defines the model as follows, Notes: please be informed the following features are option. Please indicate with your ...
Please refer to chapter 3.3.3.2 to configure. Chapter 2 2 Hardware Installation This chapter mainly describes the appearance, model and function of H700 series and how to install and set the configurations. 1. Overall Dimension 2. Accessories Description 3.
Attention: Do not install H700 series or connect/disconnect its cable when it is power on. 2.4 SIM/UIM card installed If your router has SIM/UIM card protector, please remove it, insert the sim card correctly, and fix the protector.
Pin 2 Port 9 (TX) Pin 3 2.6 Grounding To ensure a safe, stable and reliable H700 series operation, Router cabinet should be grounded properly. 2.7 Power Supply H700 series can be applied to complicated external environment and usually the power range is very large.
Please connect the antenna after you successfully connect to the cable. And then insert the valid SIM/UIM card and provide the power to the H700 series via the cable. After provide the power to H700, if the SYS LED starts to blink in a few seconds, that means the system start-up is normal;...
3 Software configuration 3.1 Overview H700 series routers with built-in WEB interface configuration, management and debugging tools, user should configuration the parameters first; and it could be altered the parameters flexibility and software upgrades and simple testing. User can set up and manage the parameters of the router on its interface, detail step are bellow: 3.2 How to log into the Router...
Typical Application (2) E-Lins Router as PPTP Client --- Connects --- Other Router/Windows as PPTP Server: Once PPTP setup, the E-Lins router will add the route itself automatically. But the PPTP Server will not add the route automatically. So need manually add it.
Typical Application (2) E-Lins Router as L2TP Client --- Connects --- Other Router/Windows as L2TP Server: Once L2TP setup, the E-Lins router will add the route itself automatically. But the L2TP Server will not add the route automatically. So need manually add it.
For some version of firmware, it requires uploading bootloader also. Please operate at the following picture. But most of time it no need do this step unless E-Lins guide or inform you to upload bootloader.
3.4 DIO This DIO feature only supports output signal to connected devices. Not support input from external devices. This DIO feature must be used with E-Lins DIO control board. 3.4.1 DIO Hardware Connection There are two types to provide power for the DIO control board.
Page 94
Notes: the set phone number MUST be same as indicated in the Sys Log. If not the same, please make the same. Refer to manual at Chapter 3.3.9.1 or FAQ from E-Lins websites. Test Feedback...
Solution: 1. Check if the power adapter connector is loose from the router. 2. Try to replace a power adapter. H700 series router uses 9V1A or 9V2A or 12V1A or 12V1A or 12V2A power adapter with 2.5mm connector 3. Router hardware defeated. Send back to factory for check or repair.
H700 LAN IP from 192.168.8.1 to 192.168.1.1 or 192.168.0.1, also do not forget to manually change the H700 Default Gateway to 192.168.1.1 or 192.168.0.1 meanwhile. 3) with the following steps, normally it can solve the issue. Otherwise, please contact E-Lins Sales or Support. E‐Lins Technology Co.,Limited ...
Need help?
Do you have a question about the H700 Series and is the answer not in the manual?
Questions and answers