Windows Nt (Arc) Console Menus - DEC AlphaServer 1000A Owner's Manual

Then turn the system off and then back on. This procedure loads the firmware. Once
the Windows NT firmware is loaded and the system is initialized, the system displays
the Windows NT Boot menu.
As an alternate method, you can use the following command to switch from the SRM
to the ARC console in your current session but return to the SRM console if you turn
off the system:
>>> arc

Windows NT (ARC) Console Menus

The Windows NT (ARC) console has three primary menus: the Boot menu, the
Supplementary menu, and the Setup menu.
Boot Menu Functions
The Boot menu contains menu items that allow you to perform the following tasks:
Boot the default boot selection
Boot an alternative boot selection
Run a program
Access the Supplementary menu
Supplementary Menu Functions
The Supplementary menu contains items that allow you to perform the following
tasks:
Install new firmware
Install Windows NT from a compact disc
Access the Setup menu
List the ARC firmware device names for the installed devices
Return to the Boot menu
4-10 Basic Operation
Note: If the screen display shows option device names
flashing, see "Troubleshooting," later in this guide.
AlphaServer 1000A Owner's Guide