DEC AlphaServer 1000A Owner's Manual page 108

Installing the CPU Card
To install the CPU card, refer to Figure 5-17 and follow these steps:
1. Slide the card into its designated slot on the system board making sure it slips
entirely into the slot.
2. Press inward on the handle clip on each end of the card until they catch in a
closed position.
3. Place the crossbar in position and screw in the single retaining screw.
Removing/Replacing Other Options
The following components should be installed by a qualified service representative
only:
System board
System backplane
System fans
Interlocking sensor switch
Front bezel
Operator control panel
For assistance in removing or installing these components, contact your authorized
service representative.
5-28 Installing and Removing Components AlphaServer 1000A Owner's Guide