Installation Procedure - Electrolux EHG313BA User Manual

18

InStALLAtIon proCEDurE

1. the bench cutout should be made as per cutout
dimensions in table 2 and figure 6.
2. adjacent walls, cupboards and protection for
combustible materials: Ensure that the appliance is
installed in accordance with clauses 6.2.5 and 6.10.1.1
ofAS/NZS5601.1,orclauses6.9.1and6.9.5ofAS/
nZS 5601.2 with regard to clearances to combustible
surfacesandmaterials,andclearancestorangehoods
and exhaust fans.
to ensure clearances of 200mm from burners to
vertical combustible surfaces observe the minimum
distance requirements shown in figure 7.
Clearances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
withclause6.10.1.2ofAS/NZS5601.1,orclause6.9.2
of AS/nZS 5601.2.
3. Barrier: A barrier must be installed to prevent
accidentalcontactwiththecooktopbase,wherethe
base of the cooktop is accessible from below (i.e.
Insideacupboard,etc.).Animpressionhasbeen
incorporated into the base to ensure a minimum
clearance of 15mm is maintained between the base
and the barrier. this barrier may be made of any non-
combustible,rigidmaterial.
note: An alternative to the above is to purchase a
barrier shield from Electrolux spare parts (p/no. ACC
072)whichcanbefitteddirectlytotheunderside
of the product. this shield protects the user from
accidently touching certain areas of the product.
Barrier protection is not necessary if the product
is installed above an underbench oven or similar
appliance and/or if the cupboard construction is such
that the underside of the cooktop is not accessible.
Figure 7a – EHG313BA
48
106
4. for Ceramic Glass models a foAm SEAL has
5. for Stainless Steel models mAStIC tApE has been
6. fit the pull down clamps supplied to ensure that the
7. on Stainless Steel models remove any excess seal
WarnInG!
Failuretofixthecooktoptothebenchcouldresultin
loosening of the gas connection through movement of the
cooktop and a gas leak may result.
four clamps and screws are supplied with 4-burner
models and six clamps and screws are supplied with
5-burner models. fit the clamps as shown in figure 8. no
clampsareneededformodelEHG313BAasitisfittedwith
spring clips on the sides which locate on the inner edge of
the bench cutout.
Whenbenchtopsarelessthan33mminthickness,itmay
benecessarytofitaspacerbetweenthebenchtopand
eachclamptoensureclampscanbetightenedsufficiently.
Combustible surface
106
been provided and is to be applied along the perimeter
of the hob.
provided and is to be placed around the bench cutout
asspecifiedinFigure8.Takecaretoensurethatthe
seals meet without overlapping.
cooktop cannot move after installation.
visible after installation.